| A
Series: Small-medium size presses, with 2 columns (T.15 2C and T.35
2C), 4 columns (T.35 4C and T.75 4C) and welded iron structure (NKT.150), where
the number means the power of the machine. These presses are very simple to
operate and it is possible to adjust the upper dead point (U.D.P.), the lower
dead point (L.D.P.), to cause the intervention of the hydraulic brake and to
reduce the down-speed through a special electronic control system. It is also
used to set the working pressure and it’s possible to use the display to read
the counter pieces, to store programs and to increase or to decrease the height
of 0.01 millimetres by pushing the appropriate pushbuttons.
  
MAIN FEATURES
- CONSTRUCTION
Forged iron structure. High
accuracy on the guiding in order to grant perfect parallelism.
- HYDRAULIC
CIRCUIT
Proportional valves and low noise pumps. Centralized
valves and hydraulic components to minimize piping and give easy
maintenance.
- CONTROLS
Computerized control cycle. All press parameters
(strokes, pressure, speed) can be set on video screen. Up to 250 different mould
programms can be stored. Interface possibility with feeding systems, robots,
etc. Programming of pressure by keyboard.
- MACHINE
DIAGNOSTIC
Autotest devices detecting possible faults with trouble shooting
instructions.
- SAFETY
Max safety for operator. Safety systems according
to CE rules included:
. side operator electric beams
. side/rear
protections
. safety reck against moving planet falling down
Through out
its engineering division LOCATELLI MECCANICA can supply "turnkey lines" for
several appliances
|
